WMJSD20 new back-end static discharge sand mill

Product Introduction

1. Adopting a combination of centrifugal turbine and annular screen ring for discharge, the production capacity is increased by about 20% compared to the traditional dynamic discharge structure; 2. Optimize the structure to clean the discharge screen ring without disassembling the dispersing disk, and significantly increase the lifespan of the discharge component; 3. Choose an integrated dual end mechanical seal to significantly improve the service life of the mechanical seal, and at the same time, the stability of the mechanical seal is also better, especially suitable for grinding various water-based materials; Various materials can be used for the grinding chamber section; 5. Adopt spiral guide groove for forced cooling, supplemented by end cap cooling.

Product Name

Sand grinder

Application scope

Water based industrial coatings, water-based automotive paints, water-based furniture paints, water-based inks, water-based suspensions, etc

Main technical parameters

Main motor power: 22kw

Cylinder volume: 20L

Material viscosity: ≤ 10PA S

Pump air consumption: 0.2 ³ m/min

Production capacity: 50-500Kg/h

Dimensions: 1700mm * 900mm * 1650mm

Application area 

Water based industrial coatings, water-based automotive paints, water-based furniture paints, water-based inks, water-based suspensions, etc