1816 H06-5 epoxy zinc-rich coating

Product introduction

1816 is a two-component amine-cured epoxy zinc powder coating. The zinc powder contained in thecoating provides excellent cathodic protection for steel. This product has fast drying performance, excellentadhesion and impact resistance, and may be used together with a lot of products.

Recommended applications

This product can be used as a general anti-corrosion primer in severely corrosive environment and widely used on all steel surfaces.

Product information

Appearance：Metallic gray

Volume solids：56±3%

Proportion：91 :9(weight ratio)

Mixture's pot life：2h (20℃)

Full cure：7d  (20℃)

Recommended DFT：60 μm (corresponding WFT=92 μm)

Theoretical quantity required (60 μm)：4.35 m² /kg

SG：2.1 kg/L

Flash point：25℃

VOCs：309 g/L

Construction conditions

Remove the contaminants(e.g. oils and greases) withappropriate detergent.

Sand blast to Sa2.5.

Surface roughness: Medium(g)(ls0 8503-2).

The substrate must have a temperature >3°C above the dewpoint.The environment should be <85%RH.

Use this product only when the painting and curing can becarried out normally at above -10°c. The painting surface mustbe clean and dry.

It is suggested that the temperature should not exceed 40°Cduring painting.

Painting method

Painting methods：airless spraying/air spraying/brush coating/roller coating

Diluent：103 epoxy diluent

Dilution：0-5% of the coating weight, The actual addition may be adjusted according to the field painting method

Nozzle size：0.43-0.53 mm

Spraying pressure：25 Mpa

Note: lf the maximum repainting interval is exceeded, the surface should be thoroughly polished and roughedbefore painting to ensure the adhesion between coats. Also remove zinc salts and other contaminants.

Film thickness：Normal dry film thickness of a single coat: 40-100μm. The thickness of paint film must be under strict control during painting.
The maximum dry film thickness should not exceed 200μm.

Packing specifications：Component A: 32.5kg,Component B:3.2kg

Shelf life：Base material: 12 monthsCuring agent: 24 months

Safety measures：Refer to our Material Safety Data Sheet(MSDs)

Disclaimer: The above produtiformatin and data are accumulated acordina to ou experience in experiments and pracicaluse, and can be used as a constuction quideFor painting works that we are not informed, we ony guarantee the qualty ofthe coating itsel,butwe are not responsilble for other problems. We have the righto modify thimanualdue to the continuous improvement of our product.